Advertisement
I
& O
NSTALLATION
PERATION
Route the connecting two-conductor wire
to the Main System Unit. Connect the ends
of the wire to the corresponding positive
and negative terminals labeled "Flasher" on
the Main System Unit (See Figure 4).
FIGURE 4 Connecting the IRC-1 to the Main
System Unit's flasher outputs.
BE SURE TO OBSERVE PROPER POLARITY
WHEN CONNECTING THE IRC-1. THE
WIRE LEAD MARKED WITH A GRAY
STRIPE IS NEGATIVE (-); THE UNMARKED
LEAD IS POSITIVE (+).
Connecting Multiple Flashers
It is possible to use more than one flasher
from a single output on a Niles infrared sys-
Over Please
8
Advertisement
