Table of Contents
Advertisement
• Frequency Band: 136-174MHZ or 400-480MHZ
• Memory channels 199.
• CTCSS/DCS encode &decode.
• Support standard and non-standard CTCSS/ DCS (CTCSS: 60Hz-260Hz, DCS: 000N--777)
• Scrambler
• Compander
• Hopping function.
• Scan and priority scan
• Vibration
• Emergency alarm
• VOX function.
• Voice prompt: capacity of battery, channel number etc.
• PC software programming
Charging the Battery Pack
1. The battery pack is not charged at the factory; Please charge it before using. After
purchasing or long-time storage (more than two months), the battery cannot reach its
normal capacity when charge the first time. After charging 2-3 times then the capacity
reaches the normal one.
2. Plug the Charger power cable into an AC outlet. Insert the battery pack or transceiver with a
battery pack into the charger. Make sure the battery pack contact with the charging
terminals correctly. The charger LED lights on and charging begins, the charge completes
when charging light turns green.
NOTE:
Do not recharge the battery pack if it is already fully charged. Otherwise, the battery life will be
shortened or damaged.
*Always switch OFF the transceiver equipped with a battery pack before charging. Using the
transceiver while charging will interfere with correct charging.
*Even after completely correct charge, the using time still not increases, then the battery life is
over, please replace the battery.
When install the battery pack, should match the corresponding location of aluminium frame of
transceiver backside, then push into the battery towards direction. The Buckles on the tail of
battery would fasten the battery pack, until can hear "clicking" sound.
To remove the battery pack, please turn off the transceiver first. Then press the buckles of the
battery, at the same time, the battery will be pushed back, take the battery away;
MAIN FUNCTION
GETTING ACQUAINTED
INSTALL/REMOVE BATTERY PACK
DELTA RADIO GROUP
Advertisement
Table of Contents
