General Safety - Toro Greensmaster 3300 Operator's Manual

Safety

General Safety

This product is capable of amputating hands and feet.
Always follow all safety instructions to avoid serious
personal injury.
•
Read and understand the contents of this
Operator's Manual before starting the engine.
•
Do not put your hands or feet near moving
components of the machine.
•
Do not operate the machine without all guards
and other safety protective devices in place and
working on the machine.
•
Keep bystanders and pets away from the machine.
•
Keep children out of the operating area. Never
allow children to operate the machine.
•
Park the machine on a level surface, lower the
cutting units, disengage the drives, engage the
parking brake (if provided), shut off the engine,
and remove the key before leaving the operator's
position for any reason.
Improperly using or maintaining this machine can
result in injury. To reduce the potential for injury,
comply with these safety instructions and always
pay attention to the safety-alert symbol
means Caution, Warning, or Danger—personal safety
instruction. Failure to comply with these instructions
may result in personal injury or death.
Roller Safety
•
The roller is only a part of a complete machine
when installed on a traction unit. Read the traction
unit Operator's Manual carefully for complete
instructions on the safe use of the machine.
•
Stop the machine, remove the key, and wait for
all moving parts to stop before inspecting the
attachment after striking an object or if there is
an abnormal vibration in the machine. Make all
necessary repairs before resuming operation.
•
Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.
•
Use only accessories, attachments, and
replacement parts approved by Toro.
Setup
1
Installing the Tri-Roller
Units
No Parts Required
Procedure
1. Park the machine on a level surface, shut off the
engine, engage the parking brake, and remove
the key.
2. Position the tri-roller unit under the suspension
arm.
3. With the latches on the suspension-arm bar
pointing up
down so that the bar fits over the bar across the
top of the tri-roller unit
, which
1. Latch—closed position
2. Suspension-arm bar
2
(Figure 3), push the suspension arm
(Figure 4).
Figure 3
3. Latch—open position
g018311