Page 1
Unpacking Instructions Auspackanleitung LIF/LIP (ML > 3040mm) This document describes the unpacking and handling of overlong LIF/LIP scales (ML > 3040 mm). For scale mounting, please refer to the separate Instructions. Scale Dieses Dokument beschreibt das Auspacken und die Handhabung von Maßstab...
Page 2
- Carefully remove the packaged scale from the shipping crate - Avoid shock, torsion, and bending - Verpackten Maßstab vorsichtig der Transportkiste entnehmen - Stöße, Torsion und Biegung vermeiden - Place the packaged scale on a flat surface (sticker facing upwards) - Cut the strap - Verpackten Maßstab auf ebenem Untergrund ablegen (Aufkleber nach oben)
Page 3
- Lift off the upper part of the packaging - Oberteil der Verpackung abnehmen - Keep the note on the warning label in mind during the entire mounting procedure The warning label is attached exactly to the fragile position of the butt joint - Hinweis auf dem Warnschild während des gesamten Montagevorgangs beachten Das Warnschild klebt exakt auf der bruchempfindlichen...
Page 4
To remove the scale from the packaging or carry it: - Place the scale on edge - To stabilize the scale, grasp it from the left and right of the butt joint Three persons are recommended to carry the scale with ML >...
Page 5
- Hold the free end of the scale - Pull off the film tubing from the other end of the scale - Freies Maßstabende festhalten - Am anderen Maßstabende den Folienschlauch vom Maßstab abziehen - Clean the machine base - Maschinenbett reinigen...
Page 6
- Place the scale with applied protective film edgewise on the mounting surface - Turn the scale (graduation side with protective film facing upwards) - Maßstab mit Schutzfolie auf Montagefläche hochkant ablegen - Maßstab umlegen (Teilungsseite mit Schutzfolie nach oben) - Peel off the protective film - Schutzfolie abziehen...
Page 7
- Place the scale on edge and clean it from both sides Use a soft cloth with isopropyl alcohol - Maßstab hochkant stellen und beidseitig reinigen Weiches Tuch mit Isopropanol verwenden - Set the scale down again with the graduation side facing upwards - Maßstab wieder mit Teilungsseite nach oben ablegen...
Page 8
DR. JOHANNES HEIDENHAIN GmbH Dr.-Johannes-Heidenhain-Straße 5 83301 Traunreut, Germany { +49 8669 31-0 | +49 8669 32-5061 E-mail: info@heidenhain.de Technical support | +49 8669 32-1000 Measuring systems { +49 8669 31-3104 E-mail: service.ms-support@heidenhain.de NC support { +49 8669 31-3101 E-mail: service.nc-support@heidenhain.de...