Sun Glow SG Wand Programming Instructions

SG Wand
Programming Instructions
To charge the motor battery only use a DC5V Micro USB Plug-in charger. When charging is complete the
wand indicator light will be
Charging time can be up to 7 hours depending on usage.
DO NOT LEAVE CHARGER IN AFTER FULLY CHARGED.
Wand Setting
Button

Basic Modes:

With the up, stop and down buttons facing forward, hook the SG wand onto the motor hook. Then plug in
the top cable. Refer to steps A, B and C.
A
Motor hook
SG Wand
Check up and down direction of shade. If incorrect follow the steps below.
Allows you to set two positions: the upper and lower limits.
Move shade up and down to test upper and lower limits.
If limits require adjustment, factor reset the motor and repeat limit setting.
Sun Glow Window Covering Products of Canada Ltd.
Manufacturer & Wholesale Distributor
50 Hollinger Road, Toronto, Ontario M4B 3G5

SG Wand Charging

solid green and the motor may beep 3 times.
Follow Steps Below to Set Motor Limits

Step 1 - Plug In Wand

B

Step 2 - Check Operating Direction

+
Press and hold. Release both buttons after
motor beeps 3 times.

Step 3 - Setting Motor Limits

Briefly Press
DC5V Micro USB
Charging Port
Indicator Light
C
Top cable
Briefly Press
Telephone: 416.266.3501 Toll Free: 800.668.1728
Fax: 416.266.5484 Toll Free: 877.245.9943
1 of 2
Page
16/06/2021
Up
Stop
Down
www.mysunglow.com