Sun Glow SG Programming Instructions Manual

MOTOR INFORMATION
1. Ensure motor is protected. Any damages during transportation, storage, installation or misuse can cause the motor
to not work properly.
2. Charge the motor every 6 months to ensure optimal performance.
3. If the battery charge is at a lower level, the motor will beep 10 times to prompt that it needs to be charged.
4. Maximum running time of the motor is 6 minutes without limits. Motor will be asleep after six minutes has passed.
Motor will still be in wake up/programming mode once the motor has restarted.
CONTROL RANGE
SIGNAL STRENGTH AND RANGE
MAY VARY DEPENDING ON THE
ACTUAL ENVIRONMENT.
Temperature
RECHARGING THE MOTOR
To recharge the motor's battery, connect the SG DC charger to the motor head charging jack and plug the charger into a
standard electrical outlet. When the battery is fully charged, the indication light on the charger will switch from red to green.
You can also use the SG Solar Panel to keep the battery constantly charged while exposed to sufficient sunlight.
IF PURCHASING MORE THAN ONE CHARGER, PLEASE ENSURE THE OUTPUT
VOLTAGE ON THE CHARGER AND MOTOR MATCH.
Charger Light
SG BI-DIRECTIONAL MOTOR
Programming Instructions
TECHNICAL SPECIFICATIONS
55°C
-10°C
Working
Programming resides with the motor. Each motor can store up to
20 copied channels.
Roller Shade
Remote
L1
L1 Open Area L2 With Obstructions
200m
Obstructions
Emission Frequency
35m 433.92/868 MHz
1 of 7
02/05/2019
L2