Advertisement
3.
OPERATION
3.1
IR Measurements
3.1.1
Point the meter towards the object to be measured.
3.1.2
Press and hold the MEASURE button. (fig.1.6)
3.1.3
The meter and laser will turn on and take a reading.
3.1.4
Read the measured temperature on the displayed LCD.
3.1.5
The meter will turn OFF aprox 7 - 8 seconds after releasing the button.
Note:
The object being measured should be larger than the spot size (see fig. 2).
Measurement considerations: If the surface of an object to be measured is covered with frost, dust or other materials, surface
cleaning must be performed before accurate measurements can be made.
Highly Reflective Surfaces: If the surface of an object to be measured is highly reflective, apply masking tape or flat black paint to the
surface (black has a fixed emissivity value).
3.2
Backlight Function
3.2.1
Press the
key (fig.1.2) to turn on the LCD backlight function. The backlight will turn off automatically approximately 8
seconds after the backlight button is released.
3.3
Displaying °F or °C
3.3.1
Open the battery compartment and remove the batteries.
3.3.2
Move the slide switch located in the opening beneath the batteries to °C or °F. (Fig.3)
3.3.3
Replace batteries and battery cover and check the display shows the chosen value when taking a temperature reading.
Fig.3
4.
STORAGE AND CLEANING
WARNING! DO NOT attempt to repair or service your thermometer, refer to an authorised service agent.
p
4.1.
Periodically wipe the case with a damp cloth and mild detergent. Do not use solvents.
4.2.
Turn the meter off when not in use and remove the batteries if stored for a long period of time.
4.3.
Do not store the meter in a place of high humidity or high temperature
INFRARED LASER THERMOMETER 6:1
Model: VS903
EN 60825-1 Laser Safety
93/68/EEC CE Marking Directive
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: Call 01284 757525 for our catalogue & promotions. Leave your full name, address & postcode.
Fig.2
Declaration of Conformity
product listed here is in conformity with the following standards and directives.
The construction file for this product is held by the Manufacturer and may
be inspected, by a national authority, upon request to Jack Sealey Ltd.
Signed by Mark Sweetman
For Jack Sealey Ltd. Sole importer into the UK of Sealey Professional Tools.
Sole UK Distributor,
Sealey Group,
Bury St. Edmunds,
Suffolk.
°C - °F Switch
We, the sole importer into the UK, declare that the
01284 757500
01284 703534
2nd June 2005
sales@sealey.co.uk
e-mail
www.sealey.co.uk
Web
VS903 - 1 - 020605
Advertisement
