JVC HR-S7600EK Instructions Manual page 3

CAU TIO N
When you are not using the recorder for a long period of time, it is recommended that you disconnect the
power cord from the mains outlet.
Dangerous voltage inside. Refer internal servicing to qualified service personnel. To prevent electric shock or
fire hazard, remove the power cord from the mains outlet prior to connecting or disconnecting any signal lead
or aerial.
The STANDBY/ON
current on and off. "
Video tapes recorded with this video recorder in the LP (Long Play) mode cannot be played back on a single-
speed video recorder.
Failure to heed the following precautions may result in damage to the recorder, remote control or video
cassette.
1. D O N O T place the recorder . . .
... in an environment prone to extreme temperatures or humidity.
... in direct sunlight.
... in a dusty environment.
... in an environment where strong magnetic fields are generated.
... on a surface that is unstable or subject to vibration.
2. D O N O T block the recorder's ventilation openings.
3. D O N O T place heavy objects on the recorder or remote control.
4. D O N O T place anything which might spill on top of the recorder or remote control.
5. AVO ID violent shocks to the recorder during transport.
M O ISTU RE CO N D EN SATIO N
Moisture in the air will condense on the recorder when you move it from a cold place to a warm place, or under
extremely humid conditions—just as water droplets form in the surface of a glass filled with cold liquid. Moisture
condensation on the head drum will cause damage to the tape. In conditions where condensation may occur, keep
the recorder turned on for a few hours to let the moisture dry.
ABO U T H EAD CLEAN IN G
Accumulation of dirt and other particles on the video heads may cause the playback picture to become blurred or
interrupted. Be sure to contact your nearest J VC dealer if such troubles occur.
Downloaded from: https://www.usersmanualguide.com/
button does not completely shut off mains power from the unit, but switches operating
" shows electrical power standby and " " shows ON.
3