minus40 B200/40/220H Instruction Manual

B200/40/220H Instruction Manual
B200/40/220H
Congratulations on your new Minus40 Refrigerator!
This premium product incorporates the latest innovations in
refrigeration technology with a highly durable design. Properly
maintained, the unit(s) will provide many years of reliable service.
Please read the following instructions carefully as it contains
important information concerning the safety, installation, operation and
maintenance of your Refrigerator.
SAFETY INSTRUCTION
• Always disconnect the unit from the mains supply before
attempting to do maintenance or before removing the bottom
grille.
• In case of unit failure, disconnect it from the power supply and
contact your service technician or supplier for advice.
• If the supply cord is damaged it must be replaced by the
manufacturer or its service agent or a similarly qualified person
in order to avoid a hazard.
MINUS40 (PTY) Ltd
Tel: +27 (0) 21 386 2290 | E-mail: service@minus40.co.za
Vaccine Fridge
INSTALLATION GUIDE
Follow these easy steps to Install your new Minus40 unit.
• Remove all wrapping and packing material.
• Position the unit out of direct sunlight and away from any other
sources of heat.
• The maximum ambient temperature in which the unit will function
is 43°C.
• The unit may not be built into a furnishing fixture or have its back
to the wall.
• The unit "breaths" through the grill, and if blocked, the unit will not
operate properly, damaging the compressor.
• Ensure the unit is perfectly level for the door(s) to function
properly.
• Built-in Voltage Stabiliser
Note: The Voltage Stabiliser has a 3 to 5-minute time delay once
switched on
VOLTAGE STABILISER
This premium product incorporates a built-in voltage stabiliser that
regulates the power supply and ensures a stable voltage supply
to the refrigerator to maximise equipment efficiency and reduce
damage and downtime caused by a power surge.
POWER SUPPLY
DO NOT CONNECT THE UNIT TO THE MAINS SUPPLY UNTIL YOU
HAVE READ THE FOLLOWING INFORMATION.
• The power supply should be in accordance with the electrical
specifications listed on the rating plate. The rating plate can be
located inside the unit on the top right-hand side.
• Always ensure that the electrical connection is suitably earthed.
• An inadequate electrical installation can result in voltage
reduction at the compressor or cause damage to the motor.
• If in doubt about any of the electrical matters mentioned above, a
suitably qualified electrician should be consulted.
• When all of the electrical requirements have been satisfied, the
unit may be plugged into the mains socket.
ALWAYS USE A DIRECT CONNECTION TO THE PLUG OUTLET
EXTENSION CORDS SHOULD NEVER BE USED.
LOADING GUIDE
When loading the unit
• Always ensure that you do not block the internal air vents and
always allow space for the cold air to circulate around contents
and the inside of the unit.
• The Minus40 is designed to automatically evaporate the
condensate water in the compressor compartment.
MAINTENANCE INSTRUCTIONS
Repairs:
• Before carrying out any maintenance or repair work, please
ensure that the unit has been disconnected from the mains
supply.
• Any service performed on these refrigerators within the
1-year warranty period MUST be cleared and reported to the
manufacturer. Failure to do this will void the standard warranty.
VOLTAGE STABILISER INSTRUCTIONS
This premium product incorporates a built-in voltage stabilizer that
regulates the power supply and ensures a stable voltage supply to
the refrigerator to maximise
equipment efficiency and reduce damage and downtime caused by
a power surge.
Operation principles LED light:
The voltage stabiliser is located in
the refrigerator base, the bottom
grille/service door needs to be
open.
Under/ Over voltage
RED:
Amber/Yellow: Delay
Green: Good power supply
V2_02/23