Palmetto Craft Palmetto Boon Table Assembly Instructions

Shown as serving table
Palmetto Boon
1. Lay table top face-down on level surface. Attach 4 legs by inserting
(4) 2 3/4" bolts through pre-drilled holes in table top into pre-drilled
holes in the top of legs. Add washers and nuts (see figure 1).
Hand tighten.
Pro Tip: Make sure lines marked for middle shelf on all four legs are
facing in before moving to step 2.
2. Turn table onto its side. Attach middle shelf by inserting (4) 2 3/4"
bolts through pre-drilled holes in middle of legs into pre-drilled holes
in middle shelf. Add washers and nuts (see figure 2). Hand tighten.
3. Add (4) Square-head screws in pre-drilled holes securing top of
table to top of legs
(see figure 3).
4. Attach triangle shelf supports (2) to front of backboard using
pre-drilled holes and (4) square-head screws (see figure 4).
5. Attach small shelf to triangle shelf support using (4) square-head
screws through the pre-drilled holes in the top of the shelf (see figure 5).
6. Next insert final squarehead screw into pre-drilled hole found on
opposite side of backboard attaching backboard to top shelf.
Pro Tip: Decide now how you would like to assemble your Palmetto
Boon Table.
7. Attach backboard to table by inserting (2) 2 3/4" bolts through
pre-drilled holes in backboard into pre-drilled holes in table.
Add washers and nuts. Hand tighten.
Potting Bench: 6a. Attach backboard upright (see figure 6a)
Serving Table: 6b. Attach backboard upside down (see figure 6b).
8. Wrench tighten all nuts and bolts.
For support, contact (866) 705-9190, support@palmettocraft.com, or visit palmettocraft.com
QUALITY AMISH-MADE FURNITURE
Complete assembly videos can be found on
palmettocraft.com
™
Assembly Instructions
Table
Important Note:
Your furniture has been
kiln-dried and ready to
stain, paint or water seal to
help preserve it and Keep it
looking nice longer. (You may
need to tighten all bolts
and nuts periodically due
to the natural expanding/
contracting of wood.) Please
note, exposure of all woods to
outdoor elements can cause
fading, warping, cracking,
shrinking or expansion. The
manufacturer and distributor
of this product cannot be
held responsible for damage
or changes caused by natural
weathering.
Shown as potting bench
Best Tools Needed
For Assembly:
• Drill • Socket • Hammer
Hardware
Included:
• (10) 2 3/4" bolts
• (10) Washers
• (10) 7/16" Nuts
• (13) Square-head screws
• Square-head drill bit