Palmetto Craft Palmetto Boon Table Assembly Instructions

Shown as serving table
Palmetto Boon Table
1. Lay table top face-down on level surface. Attach 4 legs by
inserting (4) 2 ½" bolts through pre-drilled holes in table top into
pre-drilled holes in the top of legs. Add washers and nuts
(see figure 1). Hand tighten.
2. Turn table onto its side. Attach middle shelf by inserting (4) 2
½" bolts through pre-drilled holes in middle of legs into pre-drilled
holes in middle shelf. Add washers and nuts
(see figure 2). Hand tighten.
3. Attach small shelf to triangle shelf support using (2) square-
head screws through the pre-drilled holes in the top of the shelf
(see figure 3). Repeat with 2nd triangle shelf support.
4. Align pre-drilled holes in triangle shelf supports with pre-drilled
holes in front of backboard. Attach using (4) square-head screws
(see figure 4a). Finish securing the shelf by driving the last (2)
square-head screws into the pre-drilled holes in the back of the
backboard (see figure 4b).
5. Attach backboard to table by inserting (2) 2 ½" bolts through
pre-drilled holes in backboard into pre-drilled holes in table. Add
washers and nuts. Hand tighten.
Potting Bench: 5a. Attach backboard upright (see figure 5a)
Serving Table: 5b. Attach backboard upside down (see figure 5b)
6. Wrench tighten all nuts and bolts.
For support, contact (866) 705-9190, support@palmettocraft.com, or visit palmettocraft.com
QUALITY AMISH-MADE FURNITURE
Complete assembly videos can be found on
palmettocraft.com
Assembly Instructions
Shown as potting bench
Best Tools Needed
For Assembly:
• Drill • Socket • Hammer
Hardware
Included:
• (10) 2 1/2" bolts
• (10) Washers
• (10)7/16" Nuts
• (10) Square-head screws
• Square-head drill bit
Important Note:
Your furniture has been
kiln-dried and ready to stain,
paint or water seal to help
preserve it and keep it looking
nice longer. You may need
to tighten all bolts and nuts
periodically due to the natural
expanding/contracting of
wood. Please note, exposure
of all woods to outdoor
elements can cause fading,
warping, cracking, shrinking or
expansion. The manufacturer
and distributor of this product
cannot be held responsible for
damage or changes caused by
natural weathering.