Subscribe to Our Youtube Channel
Related Manuals for Daewoo DAMAX Series
Summary of Contents for Daewoo DAMAX Series
- Page 1 DAMAX SERIES Battery charger/starter USER'S MANUAL www.daewoopowerproducts.com Manufactured under license of Daewoo International Corporation, Korea...
-
Page 2: Table Of Contents
INDEX 1.DESCRIPTION............................2 2.THE ELECTRICAL CIRCUIT........................2 3. THE SCHEME OF THE FRONT PANEL ....................2 4. TECHNICAL CHARACTERISTICS......................4 5. INSTALLATION............................4 6.CONNECTION............................5 7.OPERATION............................... 5 8. SAFETY REGULATIONS........................... 9 9.MAINTENANCE............................10 10.WARRANTY............................11... -
Page 3: Description
INTRODUCTION Dear customer, Thank you for your trust and for buying our product. Before use, please read all the rules in this manual. For the most optimal and long-term use should be strictly the instructions for operation and maintenance. In your interest suggest that the maintenance and possible troubleshoo- ting instructed you to our service center, since we have the equipment and trained personnel. - Page 4 4. 1/2 switch the charging current 5. Ammeter 6. output terminal12/24 V 7. Fuse...
-
Page 5: Technical Characteristics
1. Current setting ,'' normal charge / faster charge'' 2. Charging time setting Model 3. output terminal “ -” 4. output terminal “+ 24 V “ 5. output terminal “+ 12V “ 4. TECHNICAL CHARACTERISTICS: Parameter Table1: Model DAMAX 320 DAMAX 420 DAMAX 520 DAMAX 600... -
Page 6: Connection
rough handling. After storage in a cold or damp room, and after transport, the device before switching should be allowed under normal conditions for at least 2 hours The main condition for normal charging is that it correctly (see the manual for the battery.). 1). - Page 7 charge, did not exceed the parameters set by the manufacturer pre-charger. 1). Remove lids / caps on the battery (if any) to allow free exit to allocate gas. Check that the level of the electrolyte battery cover plate. If they were not covered, add distilled water until the level was 5 to 10 mm above the plates.
- Page 8 Switch 1/2 - switches for charging currents, is used only in the normal charge (MIN) Charge-starter DAMAX 520 / 600 Terminal "-" - not removable and connects to the "-" battery. Depending on the battery voltage 12/24V terminal marked "+" are mounted on the respective output 12V or 24V on the front panel and connect to the battery.
- Page 9 Table 5. Connecting the 24 V The end of the charging process. When charging is complete, unplug the power by setting the switch to the position "OFF", and then pull the plug. Then disconnect the terminals from the battery and place the pre-charger in a dry place. Starting your device.
-
Page 10: Safety Regulations
8. SAFETY REGULATIONS Start-charger should only be used to charge the battery, and to start a car engine, not for other purpo- ses. Their service is allowed only by trained and experienced persons. The user must comply, as well as all safety instructions to be provided to the safety and security of the third party. It is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience or knowledge, unless they are controlled or not instructed on the use of the appliance by a person responsible for their safety. -
Page 11: Maintenance
9. MAINTENANCE. Attention!!! After work or finding pre-charger at low temperatures below (+5 C), do not turn the unit for 2 hours after moving it to a warm place, to avoid condensation. Warning: Switch off electrical power before maintenance Regularly remove accumulated dirt and dust from the inside with compressed air. Do not directly use air flow to the electrical components to avoid damaging them. -
Page 12: Warranty
WARRANTY CARD Product model Date of sale Company Serial number Client's signature Username The product is in good conditions and fully complete. Read and agree the terms of the warranty. GUARANTEE The warranty period starts from the date of sale of the products and covers 1 year for all power products. During the warranty period, free failures caused due to the use of poor-quality materials in the production and manufacturer workmanship admitted fault are removed. - Page 13 Manufactured under license of Daewoo International Corporation, Korea...
Need help?
Do you have a question about the DAMAX Series and is the answer not in the manual?
Questions and answers