Advertisement
3. Installation Ladegerät
Note:
The instructions for use enclosed with the
outer packaging of the charger also apply and
must be observed!
3.1 Installation
● The charger must be mounted on the wall in an
upright position and free of vibrations.
● Connection to a 1-phase power supply with 230V
(3-phase, 400V with Rotan ™ 245 BTX).
Blue LED lights up
blue
Electricity supply
yellow Battery is charging
green
Battery full charged
red
Error
3.2 Start the charging process
● Pull the machine plug [25] out of the machine socket
[26].
● Connect the charging plug to the machine socket
[26].
The loading process starts automatically.
3.3 Interrupt the charging process
● Press the stop button (
)
The yellow charging LED goes out.
● Remove the charging plug from the machine socket
[26], connect the machine plug [25].
10
4. Battery information
Warning:
Connect the machine with XFC batte-
ries to the charger after each use, i.e. continuous-
ly charge them. Never park the machine deeply
discharged for longer than 2 days.
● Always pull the machine plug out of the machine
socket after the end of operation.
● The full battery capacity is reached after about 8
charge / discharge cycles.
● Batteries supplied by Gmatic
are maintenance-free
®
as standard. There is no need to refill distilled water.
● The machine sockets (SBE160) are mechanically
coded; accidental charging with other existing
chargers is thus prevented.
● Battery life: optimal temperatures are between
20 ° C and 25 ° C. Higher temperatures reduce
the lifespan, lower temperatures the capacity,
temperatures below + 10 ° C and above 35 ° C must
be agreed with the manufacturer!
● The batteries are low in gassing, but not gassing-
free. Make sure that the gases are removed properly
during the charging process; especially in the battery
room do not place any objects.
● Deeply discharged batteries can freeze.
● The battery life is measured in the number of
discharge or charge cycles - the deeper the battery
discharge, the lower the number of cycles.
● Check plugs and cables for damage every week
● Loss of stored energy in all batteries due to creeping
self-discharge without a charging connection.
● Always keep batteries clean and dry to avoid external
leakage currents between the battery terminals.
Carry out cleaning accordance to the ZVEI leaflet
„Cleaning batteries".
Report faults on the battery or charger immedia-
tely:
Hotline: +49 2389 40 30 20
5. Installation
Warning:
Batteries require before the fi rst Com-
missioning a full initial charge!
5.1 End the charging process
● Remove the mainsplug from the socket.
● Pull the charging plug out of the machine socket [26]
● Insert the machine plug [25] into the machine socket
[26].
5.2 Filling the fresh water tank
● Open the fuel cap [13].
● Fill fresh water tank with cleaning liquor up to max.
10 cm below the top of the container.
We recommend the use of the canister dispenser
KD-12 (Art. No. 260102CS) to fill the fresh water
tank.
● Carefully close the tank cap [13] by lifting the
compensation hinges.
5.3 Close attachments (ensure vacuum)
● Close the drain hose [17] tightly with the plug.
● Tur off ball valves (fresh and dirty water).
● Check that the tank cap [13] lies flat and is seated
correctly.
5.4 Adjust seating position
● Adjust the inclination angle of the backrest to the
posture of the machine operator by actuating the
backrest adjuster.
11
Advertisement
