Table of Contents
Advertisement
General Precautions
Handling Precautions
Do not leave the product in excessive heat such as
z
in a car in direct sunlight. High temperatures can
cause the product to malfunction.
If the lens is taken from a cold environment into a
z
warm one, condensation may develop on the lens
surface and internal parts. To prevent condensation
in this case, first put the lens into an airtight
plastic bag before taking it from a cold to warm
environment. Then take out the lens after it has
warmed gradually. Do the same when taking the
lens from a warm environment into a cold one.
The lens interior may appear to waver, but this
z
does not indicate a defect or failure, and will not
cause any problems in use.
In order to optimize aperture control, there are
z
occasions in which the aperture blades will move
during zooming and focusing, even when the
aperture value is set for aperture-priority AE or
manual exposure, etc.
Please also read any lens related handling
z
precautions listed in your camera's instruction
manual.
Shooting Precautions
Focus again after recovering from the auto power
z
off status.
To maintain the focus position in the shooting-ready
z
status, set [Auto power off] to [Disable] on the
camera.
ENG-3
Advertisement
Table of Contents
