Preventing Equipment From Falling Over - Pioneer PDK-TS14 Operating Instructions Manual

Preventing Equipment from Falling Over

After installing the stand, be sure to take special care to ensure that the equipment will not fall over.
Stabilizing on table or floor
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
To stabilize the equipment on a
table or on the floor, use
screws that have a nominal
diameter of 6 mm (1/4 inch)
and that are at least 20 mm
(13/16 inch) long.
Position of table/floor screws
When stabilizing the stand to a table or the floor, use
nominal diameter 6 mm (1/4 inch) with a length above 20
mm (13/16 inch).
Unit: mm (inch)
120
(4-23/32)
Side View
Using a wall for stabilization
1
2
Min. 20 mm
(13/16 inch) Note
Use hooks, ropes, chains, and
fittings that are available on the
market.
Recommended hook:
Nominal diameter M8
Length 12 to 15 mm (1/2 to 5/8 inch)
2
Fitting
478
(18-13/16)
• A table or an area of the floor with adequate strength
• When installing the Plasma Display, please take the
• If you do not take these precautions, the Plasma
• The screws, hooks, chains and other fittings that you
• Select the appropriate screws, hooks, chains and other
Attaching falling prevention bolts (hooks)
to the Plasma Display.
Using strong cords or chains to stabilize it
appropriately and firmly to a wall, pillar, or
other sturdy element.
Perform this work in the same way on the left and right
sides.
Cord or chain
1
Hook
Caution
should always be used to support the Plasma Display.
Failure to do so could result in personal injury and
physical damage.
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as
earthquakes, or of accidents.
Display could fall down and cause injury.
use to secure the Plasma Display to prevent it from
overturning will vary according to the composition and
thickness of the surface to which it will be attached.
fittings after first inspecting the surface carefully to
determine its thickness and composition and after
consulting a professional installer if necessary.
12 to 15 mm
(1/2 to 5/8 inch)
5
En