Advertisement
Installing the Twilight Golf Post (TWGP-STAKE)
WARNING: Risk of electric shock. Turn
off power before servicing. Install all post
lights 10 feet (3.05m) or more from a pool,
spa, or fountain.
1. Remove sod and excavate a 12" deep (below
aeration depth) trench for the UF supply line
cable or conduit and lightpost. The lightpost
requires a 10" diameter hole to facilitate
installation to a depth of 18".
2. Feed the incoming UF supply line cable or
conduit through the slanted bottom of the
lightpost (Figure 5-1). Provide 30" of wire
from the bottom to allow for future servicing.
If wiring multiple light fixtures in a series, make
sure you pull the second (continuing) supply
wire through the lightpost.
3. Connect the supply wires to the ToroCap's wires
using the included wire nuts (Figure 5-2).
4. Encase all wire connections in the supplied
water-proof grease caps (Figure 5-3).
5. Push all wires back into the Landscape
LightPost and slide ToroCap back on.
6. Align holes on ToroCap with holes on the
Lightpost. Start all three included screws, then
tighten. (Figure 6).
7. Place the now wired LightPost into the
excavated trench and position to the desired
height. If wiring multiple fixtures, adjust the
incoming and outgoing supply wires or conduit
at the bottom of the LightPost so the wires or
conduit do not bind.
8. Open the cover-flap on the ToroCap. The
Twilight Golf Post Light is keyed with an
alignment screw. Align with the slot on the base
and insert the light (Figure 7).
(See Figures 8 and 9 for lamp head
adjustments.)
Figure 5
2
Insert wires into
wire nuts and twist.
30˝
1
Feed wires
through lightpost.
From transformer
Figure 6
ToroCap
TWGP-STAKE
ToroCap: TWGP-ELECREC
3
Insert wire nuts
into grease caps
and latch.
Lightpost: TWGP-STAKE
Cable: TWGP-12-2-500
To next light post
Figure 7
alignment screw
into notch
3
Advertisement
