Table of Contents
Advertisement
C.RESET
Downloaded from:
https://www.usersmanualguide.com/
5/8
6
q
1
¡
2
1
2
3
4
5
6
7
8
9
0
4
EN GAGE IN SERT EDITIN G
6
Press IN SERT .
● Your recorder enters the Insert-Pause mode. ("
and "
8
● The TV screen changes from the still picture to the
input source you are going to record.
ST ART EDITIN G
Load the source cassette and play back the segment
7
that is to be inserted. When you reach the start of the
section of the source tape that you wish to insert, press
PLAY to start the tape in your recorder; Insert Editing
begins at this point.
● "
panel.
EN D IN SERT EDITIN G
At counter "0:00:00", Insert Editing will stop automati-
8
cally while the tape continues running in the Play
mode. if you wish to stop Insert Editing before the
specified edit-out point, press C.RESET .
FO R AV IN SERT EDITIN G
If you want to replace the picture, Hi-Fi audio soundtrack and
normal audio soundtrack all at the same time...
In step 6 above, after you press IN SERT , press A. D U B also.
("
" and "
panel.)
N O TES:
● Suitable leads can be obtained from your dealer.
● Insert editing is not possible with cassettes whose safety tab
has been removed.
● When insert editing is performed on a tape that has been
recorded on another video recorder, the inserted portion may
appear distorted.
● In insert editing, the recording speed (SP/LP) is determined by
the previous recording to be replaced. If the previous
recording's speed changes within a single edit, the inserted
picture will be distorted at the switching point.
● A small portion of the recording which precedes an insert edit
may become erased.
● Insert Editing is also possible using the rear panel AV1 IN/
OUT or AV2 IN connector. When using these connectors,
make sure to select the correct input mode in step 2 .
" light up on the front display panel.)
" and "
" are displayed on the front display
" blink and "
" lights up on the front display
39
EN
", "
"
Advertisement
Table of Contents
