Carbest 37360 User Instruction page 6

DE
3. Pull the cover over the car
The elevating roof and the tailgate of the car should be closed before you pull the cover from the backside over
EN
the roof of the car.
A second person would be helpful to pull the front corners (at the belt) parallel over the roof. Then the front
corners should be placed at the top of the front shield and the rear corners at the back of the roof.
Before you open the elevating roof you should fix the belts at the door seal, so that they have a direction when
you raise the roof. To avoid damage, please note that the adjustments and the hooks of the belts are placed at
the end of the belts.
4. Raising of the roof
Now you can raise the roof as usual.
The second person prevents that the cover slides down at the side of the roof.
5. Drag down the corner of the cover
Drag down the corners of the cover gently on the belts until the position of the cover is correct.
If it is not pre-installed, then pull the pads over the belt and fix the plastic adjusting and hooks with the four
ends of the belts.
6. Fix the belts to the car
The belts will be fixed on the front to the wheel housing and on the back to the bumper.
7. Fixing of the cover
In order to reach optimal weather resistance the cover should be fixed as below:
a) Fixing at the Reimo Multirail or California-Tent adapter rail:
Insert 6 knobs on each side of the car into the rail. Pull the knobs through the eyelets of the cover from
behind to the front. You can create different climatic conditions, if you fold or overlap the frame of the cover
with the rail: ventilation or rain-proof.
6