Advertisement
Quick Links
Advertisement
Summary of Contents for Nice PLA17
- Page 1 Nice PLA17 Adaptation bracket from POP to SPOP EN - Instructions and warnings for installation...
- Page 2 GENERAL SAFETY WARNINGS AND ENGLISH PRECAUTIONS Complete instructions translated from Italian GENERAL SAFETY WARNINGS AND PRECAUTIONS GENERAL WARNINGS WARNING! Important safety instructions Observe all the instructions as improper installation may cause serious CONTENTS damages WARNING! Important safety instructions It is important GENERAL SAFETY WARNINGS AND PRECAUTIONS General warnings .
- Page 3 PRODUCT DESCRIPTION PRODUCT DESCRIPTION The adaptation bracket is necessary whenever a POP motor must be replaced with a SPOP motor. LIST OF PARTS MAKING UP THE KIT The kit includes: Adaptation bracket (1x); 6x14 metric-thread socket head cap screw 8.8 UNI 5931 white galvanised (8x); Elastic washer for galvanised white low head cap screw DIN 7980 (2x);...
- Page 4 Loosen the cable clamp (B). INSTALLATION INSTALLATION PRE-INSTALLATION CHECKS The installation must be carried out by qualified personnel in compliance with the current legislation, standards and regulations, and with the instructions provided in this manual All electrical connections must be made with the sys- tem disconnected from the mains electricity and with the back-up battery (if present) disconnected Before proceeding with the product’s installation, it is necessary to:...
- Page 5 The motor is heavy: sustain it with force during the dis- Fasten the SPOP bracket (H) to the adaptation bracket (G) using mantling phase the screws and washers provided, without tightening the screws Remove the gearmotor from the bracket by loosening the two (“Figure 10”).
- Page 6 Move the arm towards the bracket. Verify that the hole of the arm in the extended position is aligned The motor is heavy: sustain it with force during the with the hole of the bracket (“Figure 14”). assembly phase Loosen the fixing screw (P) of the bracket and adjust the Fasten the gearmotor (I) to the bracket (H) using the two V6x70 screws and the respective M8 nuts provided with the SPOP horizontal position if necessary...
- Page 7 PRODUCT DISPOSAL PRODUCT DISPOSAL As in installation, also at the end of product lifetime, the disassembly and scrapping operations must be performed by qualified personnel. This product is made of various types of materials, some of which can be recycled while others must be scrapped. Seek information on the recycling and disposal systems envisaged in the local regulations in your area for this product category.
- Page 8 Nice S.p.A. Via Callalta, 1 31046 Oderzo TV (Italy) www.niceforyou.com info@niceforyou.com...