Page 1
I/ON in wall / on wall passive studio monitor Blue Sky International 70 Sea Lane, Farmingdale, New York, 11735 USA • T: +1 516 249 1399 • F +1 516 249 8870 www.abluesky.com...
I/ON USER MANUAL • SAFETY INSTRUCTIONS READ INSTRUCTIONS - Read all safety and operating SERVICING - Do not attempt to service this product yourself. instructions before operating this product. Opening or removing covers, including any over bottom or side speaker drivers, may expose you to dangerous voltage or other RETAIN INSTRUCTIONS - Retain these safety and operating hazards.
Making the subwoofer (SUB) an integral part of the monitor system #10 X ¾” Pan Head Phillips sheet metal screws design enables the I/ON studio monitor to be mounted for the best imaging, and the SUB to be positioned for the best bass response.
The recommended monitoring angle for proper stereo imaging with music is 60 degrees Center of the woofer between the left and right I/ON monitors (see figure 2). In a 5.1 system, the center channel should be located on axis with the reference monitoring position and both the left and right...
Step 7 Remove the template from the wall Note: I/ON can only be mounted in a wall where there are no electrical wires, pipes, or bracing in the wall. Step 8 Slide the mounting rails in the drywall and secure it to the...
Note: I/ON can only be mounted in a wall where there are no electrical Step 6 Using a drywall saw, cut out the drywall on the inside of the wires, pipes, or bracing in the wall.
Once I/ON is mounted on the brackets there is .4” of clearance between the back of I/ON and the wall. If you bring the wire out in the middle Page 8 • User Manual • On-Wall Mounting Instructions...
4 - 3” long flathead drywall screws. The screws must be will have to build a 2 x 4 box to support I/ON. If the ceiling counter sunk into the 2 x 4 to clear the body of I/ON when joists are warped, you may have to cut down the 2 x 4 studs mounted.
PROFESSIONAL 5.1 CHANNEL SURROUND CONFIGURATION The I/ON Passive Studio Monitor can also be used as part of a 5.1 professional studio monitoring system. This would require the use of Blue Sky’s BMC MKII, along with a 5-channel amplifier, to power the system.
Step 3 Mute everything and make sure the 1kHz tone is OFF . using a SPL meter and Blue Sky’s test files. If you are using Blue Sky’s BMC MK II or a consumer receiver / controller for 5.1 etc.,...
I/ON USER MANUAL • 11 • TECHNICAL INFORMATION & MEASUREMENT DATA SPECIFICATIONS Sealed Enclosure: Solid MDF with 1.5” front & 5/8" rear baffle Weight: 21 pounds- 9.5 kg Dimensions: See page 13 OmniMount Inserts: Four 1/4” x 20 inserts, located on the back of the cabinet, for attachment of OmniMount type 60 brackets (www.omnimountpro.com) or Powerdrive...
Include a legible note stating your name, shipping address Blue Sky products are designed to last many years. However, if it (no P .O. boxes), daytime phone number, RA number, and a turns out that your Blue Sky product is damaged beyond repair,...
Page 16
Blue Sky International 70 Sea Lane, Farmingdale, New York, 11735 USA • T: +1 516 249 1399 • F +1 516 249 8870 www.abluesky.com...