Related Manuals for Milly and Coup Leo
Summary of Contents for Milly and Coup Leo
- Page 1 Bassinet & Seat Set Product Manual IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE...
-
Page 2: Table Of Contents
Folding the stroller Double or single mode? Configurations Setting up your bassinet Using your bassinet Setting up your seat Using the harness Using your Leo Free accessories Using Leo with a car capsule Leo maintenance Cleaning instructions Spare parts Warranty... - Page 3 Leo Product Manual Tips to avoid tears Leo is designed and tested to comply with Consumer Protection Notice No. 8 of 2007, AS 2088:2022 and AS/NZS ISO 8124-3. • FOLLOW THE MANUFACTURER’S INSTRUCTIONS. • PUT ON ALL THE BRAKES WHENEVER YOU PARK THE STROLLER.
- Page 4 The Milly + Coup Toddler Board (sold as a separate accessory) is compatible with Leo. • Leo is only compatible with select car capsule models using the approved capsule adaptors. Refer to our website for full compatibility. WHEN USING THE STROLLER WITH...
-
Page 5: Parts Checklist
Leo Product Manual Meet Leo Parts Checklist Please check that you have all the correct parts before getting started. Stroller frame 1 x Seat UV cover (located in seat footrest pocket) 1 x Stroller seat 2 x Front wheels 1 x Bassinet... -
Page 6: Setting Up Your Frame
Leo Product Manual Setting up your frame To open the frame, release the frame lock. Lift the handlebar upwards until you hear the frame ‘click’ into place. Thread the basket tab through the slot behind the rear wheel hub and secure the press stud. -
Page 7: Folding The Stroller
Leo Product Manual Folding the stroller Before folding, ensure that the brake is engaged, the front wheels are unlocked, and the handlebar is at the lowest height position. Remove the second seat, bassinet, or capsule by lifting the release levers on either side (the stroller can be folded with one seat in the forward facing position only.) -
Page 8: Double Or Single Mode
Leo Product Manual Double or single mode? Single Mode When using the stroller in single mode, the double adaptors must not be used. The bassinet or seat can be attached directly into the central connectors on the frame. Upper adaptors Double Mode Attach the two sets of double adaptors. -
Page 9: Configurations
Leo Product Manual Configurations Single mode: Seat + bassinet: You can purchase an additional seat, bassinet, or capsule adaptors on our website to enable the following configurations. Two seats: Two bassinets: Car Capsules:... -
Page 10: Setting Up Your Bassinet
Leo Product Manual Setting up your bassinet Using the fabric handles, pull the frame support rods towards the ends of the bassinet until they lock under the plastic clips. These rods will feel very tight, this is to ensure they will not become loose and collapse the bassinet during use. -
Page 11: Using Your Bassinet
Leo Product Manual Using your bassinet Attaching & releasing the bassinet from the frame Attach the bassinet onto either the central connectors of the frame for single mode or the double adaptors for double mode. To release, press the buttons and lift the bassinet up off the frame. -
Page 12: Setting Up Your Seat
Leo Product Manual Setting up your seat Line up the seat connectors with the frame and press downwards. Listen for the ‘click’ to ensure it is securely locked in place. Attach the plastic canopy connectors onto the sides of the seat frame (TIP: attach from top to bottom). - Page 13 Leo Product Manual Setting up your seat To recline the seat: press the large, round buttons on the sides of the seat connectors and tilt the seat forward or back. To remove the seat: press the oval buttons on the sides of the seat connectors and lift up.
-
Page 14: Using The Harness
Leo Product Manual Using the harness To secure and release the harness Insert each of the four harness straps into the central buckle. To release, press the button in the middle of the buckle. To adjust the length of the shoulder straps Slide the buckle along the strap to the desired position. -
Page 15: Using Your Leo
Leo Product Manual Using your Leo Rear brake When stopped, use the brake at all times by pressing down on the bottom of the red brake paddle with your foot until you feel it click into place. To start travelling again press down on the... - Page 16 • USE THE TETHER STRAP TO STOP THE STROLLER ROLLING AWAY. • DO NOT HANG ANY OTHER BAGS OTHER THAN THE LEO HANDLEBAR BAG FROM THE HANDLEBAR. DOING SO MAY UNBALANCE AND TIP YOUR STROLLER. • THE LEO HANDLEBAR BAG HAS BEEN TESTED TO HOLD 2KG.
-
Page 17: Free Accessories
UV/Sleep/Mosquito Cover There are two UV covers included with your Leo – one for the seat and one for the bassinet. The seat UV cover is located in the zipper pocket underneath the seat foot rest. - Page 18 Leo Product Manual Free accessories UV/Sleep/Mosquito Cover cont. For the bassinet: Attach the toggles to the loop fixing points on the inside of the bassinet canopy. Pull the elastic end over the foot end of the bassinet and secure the tabs on each side of the UV cover underneath the frame tube of the bassinet.
-
Page 19: Using Leo With A Car Capsule
AND STROLLER FRAME WHEN ATTACHING. • NEVER PLACE THE CAR CAPSULE IN THE CAR WHILE ADAPTORS ARE ATTACHED. The following car capsules are compatible with the Leo Capsule Adaptors. Please refer to our website for the most current compatibility list. • Maxi Cosi Citi •... -
Page 20: Leo Maintenance
Leo Product Manual Using Leo with a car capsule To remove your capsule: Apply the brake then simultaneously press the release buttons on each side of the capsule and lift the capsule off the adaptors. Note: Each capsule mentioned above will have slightly different buttons to release the car capsule from the adaptors. - Page 21 Leo Product Manual Leo maintenance POISONOUS, TOXIC SUBSTANCE. USE WITH CARE. • ENSURE CHILDREN ARE NOT PRESENT WHEN APPLYING SILICONE LUBRICANT OR ALLOWING IT TO DRY. • ALWAYS SPRAY OUTSIDE OR IN A WELL-VENTILATED AREA. • ENSURE YOU USE MINIMAL PRODUCT AND WIPE AWAY EXCESS SOLUTION BEFORE USE.
-
Page 22: Cleaning Instructions
Leo Product Manual Cleaning instructions To keep your stroller looking and functioning like new, we recommend a deep, comprehensive clean every 6 months. Refer to the cre labels on your stroller. For a full guide on how to clean your pram, please refer to our website. -
Page 23: Spare Parts
Warranty Leo comes with a 3 year defects warranty to cover against faults in materials and workmanship when your stroller is used under normal conditions, according to our user manual and technical specifications. - Page 24 Contact Us: au.support@millyandcoup.com | nz.support@millyandcoup.com Model: Leo Version: 1 - January 2023 Information subject to change. Please see website for current version. millyandcoup.com...
Need help?
Do you have a question about the Leo and is the answer not in the manual?
Questions and answers