Set-Up; On/Off And Speed Control; Angle Adjustment - ProBreeze PB-F05 Instruction Manual

SET-UP

Remove contents from the box.
1.
Attach the bottom part of the stand to the
2.
two metals arms by pushing both metal
buttons inwards and sliding both parts
together until the buttons click into place.
Place fan on a flat level floor.
3.
Adjust fan to the desired angle. It may be
4.
necessary to tighten the nuts on either side
of the fan to secure the position.
Connect the fan to a power outlet.
5.
Turn the fan On.
6.
Warning: Do not move or adjust the angle
of the fan while it is on.

ON/OFF AND SPEED CONTROL

Use the controls at the back of the fan to control
the speed and turn the fan On and Off:
- Off
0
- Low Power
1
- Medium Power
2
- High Power
3

ANGLE ADJUSTMENT

To make adjustments to the angle of the fan,
switch it off and adjust it to the desired angle
using minimal force.
If the fan doesn't adjust using minimal force,
slightly loosen the adjusting nuts at the side of
the fan by turning it anti-clockwise. Adjust the
fan to the desired angle and tighten again by
turning the nut clockwise.
5 | English
0
Adjusting Nut
1 2 3