INTRODUCTION
The CAPXSGNB is a specially designed bracket to mount the CAPXS
Smart Video Intercom S onto a pedestal/gooseneck. This bracket
replaces the standard bracket that ships with the CAPXS.
NOTE: You will reuse the same screws to secure the CAPXS to
the CAPXSGNB.
CAPXSGNB INSTALLATION
CARTON INVENTORY
CAPXSGNB mounting bracket
ADDITIONAL ITEMS YOU MAY NEED
Silicone Sealant, Phillips Screwdriver, T20 Screw Driver/Bit, Mounting
Hardware per CAPXS Installation manual
GOOSENECK BRACKET INSTALLATION
1. Mount the Gooseneck Bracket to the Pedestal Plate with appropriate
hardware (not included).
2. Remove the standard (included bracket) from the CAPXS (keep the
screws - you will reuse them).
3. To mount the CAPXS, ensure wiring is pulled thru the pedestal and
wired into the CAPXS (see CAPXS manual for wiring diagram).
4. Place and HOLD the CAPXS into the Gooseneck Bracket. (There is NO
retention to keep this in place so it must be held for the next step!)
5. Insert the 2 screws that are provided with the CAPXS and secure the
CAPXS to the Gooseneck Bracket.
6. Pedestal plates are often not a completely flat surface. To ensure a
good seal to protect the CAPXS wiring, add silicone sealant around the
bracket where it is mounted to the pedestal plate.
7. If you are mounting the CAPXS in an area that is exposed to rain
or snow, it is recommended to install some type of solid hood that
will protect the CAPXS. The CAPXSHOOD accessory can be used in
conjunction with the Gooseneck bracket but only for protection from
the sun on the touch screen (for improved visibility in direct sunlight)
and isn't meant to protect from direct rain.
WARNING: This product can expose you to chemicals
including lead, which are known to the State of California to
cause cancer or birth defects or other reproductive harm. For
more information go to www.P65Warnings.ca.gov.
Figure 1
Figure 2
GOOSENECK BRACKET
MODEL: CAPXSGNB
CAPXSGNB