Intelbras Impacta 68i Recording Card Installation Guide

The Impacta 68i recording card is an accessory card that can be used only in the Impacta 68i telephone exchange, allowing the recording of up to 8¹ audio channels. Audio files are temporarily stored on an SD² card, connected to the board itself.

The Impacta 68i recording card is not supplied with the control unit.

For more information on the configuration of the Impacta 68i recording card, configuration/reading of recordings³ and approved SD cards, consult the ICR - Intelbras Call Recorder user manual on the website www.intelbras.com.br.

¹ For recordings above 4 audio channels, it is necessary to purchase the usage license.

² Item not included and required for recording.

³ The ICR software – Intelbras Call Recorder is required (license for use required) and USB cable.

Care and safety

Attention!
Only authorized technical personnel can open the PBX cover, as well as connect and handle its interfaces.

Carefully read all equipment information and follow all safety information.

• Always consult a superior or immediate supervisor before starting work, informing the necessary procedures to perform the requested service and the necessary safety precautions.
• Turn off system power during interface assembly or removal services.
• Connect the grounding conductor to the system involved before starting. Never operate the equipment with the grounding conductor disconnected!

To avoid electrostatic damage to the Impacta 68i recording card, observe the following precautions:

Attention!
Static electricity can damage the board's electronic components. This type of damage can be irreversible or reduce the life expectancy of the device.

• Use an antistatic wrist strap, or similar, to handle the card.
• Transport and storage must only be carried out in static-proof packaging.
• Place the card on a grounded surface when you take it out of the packaging.
• Avoid touching the pins of integrated circuits or electrical conductors.
• Always be properly grounded when touching the board or any component.

Technical specifications

Product

Installation

This board can only be connected to the Impacta 68i control panel, version 3.22.00 or higher.

To connect the Impacta 68i recording card follow the procedure:

1. Turn off the AC power of the Impacta 68i control unit and remove the cover;
2. The Impacta 68i recording card must be installed in the optional slots: OPC1 or OPC2;
3. Insert an approved SD card (see Approved SD card) into the recording board as shown in the following image;
   
4. Replace the cover and turn on the AC power of the Impacta 68i control unit;

Cadence of LEDs

• Before using the card it is necessary to format it via web programmer.
• When using the SD card, check the need for formatting with the ICR – Intelbras Call Recorder manual.

Basic usage

For more information on configuring the Impacta 68i recording card and recording, consult the ICR - Intelbras Call Recorder's user manual at www.intelbras.com.br.

Homologated SD card

SDHC type, class 6 or higher (micro-SD cards are not supported).

Approved Manufacturers: Kingston^®, SanDisk^®, Transcend^®, Toshiba^®, Samsung^® and Panasonic^® (other models will not work).

Kingston is a registered trademark of Kingston Technology Company. SanDisk is a registered trademark of SanDisk Corporation. Transcend is a registered trademark of Transcend Information, Inc.