M2M MCF-LW12CO2E Manual

Table of Contents
MCF-LW12CO2E Operating Manual
Important safety information
Read this manual before attempting to install the device! Failure to observe recommendations included in this manual may be dangerous or cause a
violation of the law. The manufacturer will not be held responsible for any loss or damage resulting from not following the instructions of this
operating manual.
Do not dismantle or modify in any way.
The device is only intended for indoor use. Do not expose it to moisture.
The device is not intended to be used as a reference sensor, and enginko Srl will not be held liable for any damage which may result from inaccurate readings.
Avoid mechanical stress
Do not use any detergent or alcohol to clean the device.
Disposal information for users
Pursuant to and in accordance with Article 14 of the Directive 2012/19/EU of the European Parliament on waste electrical and electronic
equipment (WEEE), and pursuant to and in accordance with Article 20 of the Directive 2013/56/EU of the European Parliament on batteries and
accumulators and waste batteries.
The barred symbol of the rubbish bin shown on the equipment indicates that, at the end of its useful life, the product must be collected separately from
other waste.
Please note that the lithium batteries must be removed from the equipment before it is given as waste and disposed separately. To remove the batteries refer to the
specifications in the user manual. For additional information and how to carry out disposal, please contact the certified disposal service providers.
1. Description
The MCF-LW12CO2E is a battery powered sensor for indoor applications that reads temperature, relative humidity, pressure, ambient light, IAQ air quality index
and CO2. The device sends collected data over the LoRaWAN® network. Ideally suited for a wide range of applications such as home buildings, air quality
monitoring and energy saving applications.
m2m Germany GmbH | Am Kappengraben 18-20 | 61273 Wehrheim | 06081 5873860