Advertisement
HAZ is operated under unbalanced condition and could be tipped off if tripod is not secured.
Remove mount head from package.
1.
Set up tripod: The mount can be attached to a tripod
2.
with a 3/8"-16 threaded post. Extend the tripod legs.
Adjust the tripod height and level it. Tighten tripod
leg locking knob to secure the tripod. Shown below is
a carbon fiber tripod #8061A which can be used for
multiple mounts. Remove center post and alignment
peg, if there is any installed. Retreat tripod
supporting tray locking knob so the tripod center bolt
can be push up through the tripod head.
Center post
Tray locking
knob
Center bolt
locking knob
Center bolt
iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | www.iOptron.com
Attach mount head: Align the HAZ mount head base
3.
hole to the tripod center rod. Tighten the center bolt
to secure the mount. Tighten the tray lock to secure
the tripod legs.
Level the mount by adjusting the tripod legs. Use the
build-in Bubble Level Indicator or an external leveler
for this purpose.
Attach mount with a Leveling MiniPier: If an optional
4.
Leveling MiniPier is used,
(1) Check the stainless steel adapting screw and
make sure it is tightened to the base.
(2) Attach three leveling screws onto the tripod top;
(3) Attach MiniPier onto the tripod with three
leveling screws. Loosely tighten both tripod
center bolt and tripod tray locking knob;
(4) Attach the mount onto the MiniPier. Secure it by
tightening the mount locking screw on MiniPier;
2
Advertisement
