Advertisement
Quick Links
DEADBOLTS
DEADBOLTS ONLY THUMBTURN
Cod. CER-285 / CER-2854
Installation guide
HOW TO INSTALL YOUR SECURITY AUXILIARY EMBED LOCK
HOW TO DETERMINE THE DIRECTION
1
OF THE DOOR
Left
door
2
MARK THE GAPS
Select the height from the oor to install
the lock. Fold the pattern along the dotted
line. Mark pints 1 and 2 (2`).
4
INSTALL THE LATCH
Insert the latch through the 25mm hole. Mark the outline of
the front. Make a 3mm deep box. Then secure the latch.
Note: The arrow indicates the direction of installation.
For single cylinder / For double cylinder
INSIDE
EXTERIOR
www.jakohardware.com
3
DRILL THE GAPS
Drill a 54mm hole centering at point 2 (2-1/8")
Right
Drill a 25mm hole centering at the point 1
Door
5
LATCH POSITION
Indicate the installation process always with the handle
outside the case as shown in the gure. Since otherwise
the instructions of the numeral 6 are reversed.
Latch slot.
Unscaled format
Latch.
Advertisement
Related Manuals for JAKO CER-285
Summary of Contents for JAKO CER-285
- Page 1 DEADBOLTS DEADBOLTS ONLY THUMBTURN Cod. CER-285 / CER-2854 Unscaled format Installation guide HOW TO INSTALL YOUR SECURITY AUXILIARY EMBED LOCK For single cylinder / For double cylinder HOW TO DETERMINE THE DIRECTION DRILL THE GAPS OF THE DOOR INSIDE Drill a 54mm hole centering at point 2 (2-1/8”)
- Page 2 INSTALL EXTERIOR MECHANISM INSTALL THE LATCH For right doors, take the outer cylinder with the platen For a single cylinder. (knob) facing you and turn it clockwise (right) until it stops Insert the screws and secure them. and is horizontal. Then insert it through the slot in the latch. For double cylinder For left door, take the cylinder in the same direction, but turn Position the cylinder platen (knob) vertically and insert...