Advertisement
UTR 104 FRP • Installation Guide
The UTR 104 Front and Rear panels provide extra security for the Under
Table Rack by preventing unwanted contact with system products and
cabling. The front panel features a smoked acrylic window to allow visibility
of products for troubleshooting. These panels are also easily removable,
allowing for service access.
NOTE: The UTR 104 FRP can be installed either before or after the main
UTR installation.
Installing the UTR 104 Front and Rear Panels
2
Latch each panel onto its respective
top mounting pegs.
Side View
2
3
UTR 104
Front Panel
3
Swing down each panel
onto the bottom mounting pegs.
Figure 1.
Installing the UTR 104 FRP
UTR 104
Front Panel
4
4
UTR 108
1
UTR 104
Rear Panel
1
1
Insert the eight included #10-32 x 0.25 inch Phillips
truss-head screws into the eight mounting pegs,
located on the vertical rack rails of the UTR 104.
4
Lock each panel in place with two of the included
#10-32 x 0.25 inch Phillips truss-head screws.
UTR 104
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Extron electronics UTR 104 FRP
Summary of Contents for Extron electronics UTR 104 FRP
- Page 1 The front panel features a smoked acrylic window to allow visibility of products for troubleshooting. These panels are also easily removable, allowing for service access. NOTE: The UTR 104 FRP can be installed either before or after the main UTR 108 UTR 104 UTR installation.
- Page 2 Front Panel Insert the eight included #10-32 x 0.25 inch Phillips Swing down each panel truss-head screws into the eight mounting pegs, onto the bottom mounting pegs. located on the vertical rack rails of the UTR 104. Lock each panel in place with two of the included #10-32 x 0.25 inch Phillips truss-head screws.
Need help?
Do you have a question about the UTR 104 FRP and is the answer not in the manual?
Questions and answers