BRAVILOR BONAMAT Aurora Device Codes page 2

Factory defaults code:
To get access to the "factory defaults" menu, first the operators menu needs to be opened, next the "service menu"
needs to be opened with the right pin code.
Push the arrow key ► or ◄ and go to "factory defaults".
Push button M and now push within 5 seconds the code ►►►◄► with the arrow keys.
The next options will now be available:
• First start (back to first installation).
• Factory (back to factory test program),
This procedure needs to be performed by a certified technician at any time.
• Reset all counters (Reset the total counter)
• Language (upload/download/delete languages)
Warning
► The "factory" menu needs to be performed by a certified technician at any time.
Wrongly used settings can cause power overload or fire.
Bravilor Bonamat BV will not accept any liability for damage or injury caused by wrongly used settings.
TIP
► To get the machine back to the first installation like the machine was delivered from the factory, the "first start"
menu needs to be used.
If the "first start" menu will be activated, the "boiling point determination program" and the pump calibration
need to be performed again.
To perform the "boiling point determination program" the temperature of the water in the boiler needs to be
below 70°C.
First start and Factory:
Warning
► The "factory" menu needs to be performed by a certified technician at any time.
Wrongly used settings can cause power overload or fire.
Bravilor Bonamat BV will not accept any liability for damage or injury caused by wrongly used settings.
To get access to the "first start" and "factory" menu, first the operators menu needs to be opened, next the "service
menu" needs to be opened with the right pin code, next the "factory defaults" menu needs to be opened with the right
code.
Push the arrow keys ► or ◄ and go to the desired setting.
To access the "first start" or "factory" menu, push at the desired menu the M button.
Next use the arrow keys ► or ◄ to change off to on and confirm by holding button M.
Switch the machine off and after a few seconds on again, now the machine will start up with the desired menu.
Interrupt the descaling program
Open the hot water tap for at least 30 seconds.
Warning
► If the descaling program is interrupted while there is already descaler in the machine, it must be
completely drained (by the evacuation hose) and thoroughly rinsed before using the machine.
Original document by manufacturer
© 08-2019 VHH
Bravilor Bonamat B.V.
COD Special codes
Aurora