Switching Off The Heater; Malfunction, Causes And Solutions - Qlima R 3224 X Operating Manual

Hide thumbs Also See for R 3224 X:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 60
After having ignited the heater, always check whether the combustion
chamber D is level, by sliding it slightly to the left and the right by its handle
E (Fig. F). This should be a smooth movement. If the combustion chamber is
not level, this will cause smoke and soot to develop.
D
BURNING OF THE HEATER
After you have ignited the heater, it will take 10 to 15 minutes before you can check
whether the heater is burning well. Too high a flame may cause smoke and soot,
whereas too low a flame causes smells. Fig. Q (See at the end of the manual) shows
the minimum and maximum permissible burning heights of the flame. The flame
K
can be slightly adjusted with the knurled wick adjustment knob B (Fig. M).
Burning that is too low may be caused by:
E insufficient fuel
E poor fuel quality
E insufficient ventilation
L
E wastage of the wick
E

SWITCHING OFF THE HEATER

Push the OFF-button A. The flame will extinguish after a little while (Fig. N).
F
F

MALFUNCTION, CAUSES AND SOLUTIONS

If any malfunctioning cannot be solved from the directions below, please contact
your dealer.
THE HEATER DOES NOT IGNITE
E The batteries are not positioned correctly in the holder.
M
E There is not enough power left in the batteries for the ignition.
E You have run out of fuel from the tank or the wick has been replaced.
E You are pushing the ignition button C with too much force.
IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS
N
E The combustion chamber D has not been positioned correctly.
E You are using fuel which is past its 'use by' date.
E You are using the incorrect type of fuel.
E Dust has gathered in the lower part of the heater.
4
66
Push in the ignition button C (Fig. L), but do not apply too much force.
Release the ignition button as soon as a flame is visible in the combustion
chamber D.
Check (Fig. G).
Replace (Fig. G).
After having refilled and replaced the removable tank, wait for 180 minutes
before igniting the heater.
Push it in less forcefully (Section C).
Use the handle E to put it level, until you can easily slide it slightly to the left
and to the right and the chamber is level.
Start every heating season with fresh fuel.
Refer to THE RIGHT FUEL (See Section 'What you need to know in advance').
Contact your dealer.
(fill the tank)
(contact your dealer)
(put window or door ajar)
(contact your dealer or replace the wick,
refer to section L

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents