Get Started; Charge The Battery; Pair The Headphones With Your Mobile Phone - Philips 1000 Series User Manual

3 Get started

Charge the battery

Note
 Before you use your headphones for the �rst
time, charge the battery for two hours for
optimum battery capacity and lifetime.
 Use only the original USB charging cable to
avoid any damage.
 Finish your call before charging the
headphones, as connecting the headphones for
charging will power the headphones off.
Connect the supplied USB charging cable
to:
• The USB-C charging slot on the
headphones and;
• The charger/USB port of a computer.
LED turns white during charging and
turns off when the headphones in
fully charged.
Tip
 Normally, a full charge takes two hours.
Pair the headphones with
your mobile phone
Before you use the headphones with your
mobile phone for the �rst time,
pair it with a mobile phone. A successful
pairing establishes a unique encrypted
link between the headphones and mobile
phone. The headphones store the last four
devices in the memory. If you try to pair
more than four devices, the earliest paired
device will be replaced by the new one.
1
Make sure that the headphones are
fully charged and turned off.
2
Press and hold MFB for six seconds
until the blue and white LED �ashes
alternately.
The headphones remain in
pairing mode for �ve minutes.
3
Make sure that the mobile phone is
on and its Bluetooth feature is
activated.
4
Pair the headphones with the mobile
phone. For detailed information,
refer to the user manual of your
mobile phone.
The following example shows you how to
pair the headphones with your mobile
phone.
Activate the Bluetooth feature of
your mobile phone, select
Philips TAH1108
Philips TAH1108
EN 5