LG LDF5545ST Service Manual page 20

2-3. Door Liner Assembly
Fan Motor
Vent
~
Connector
Dispenser
Blower Cover
Dispenser
- 20 -
For Authorized Service Technician
1) Blower Assembly
① Remove the screw.
② Remove the vent from Fan motor.
③ Disconnect the connector.
④ Open the Door.
⑤ Remove the Blower cover
- Insert flat head screwdriver in hole (A ).
- Rotate flat head screwdriver slowly.
⑥ Remove the 3 screws.
※ Be careful not to damage blower cover.
2) Dispenser Assembly
3) How to use the Dispenser service Jig
- Remove the Dispenser
① Close the Door.
② Disconnect Electrical wire connectors
from dispenser.
③ Insert the two side pieces into the inside
of the dispenser.
④ Insert the bottom piece.
⑤ After all three pieces have been inserted,
open the door and pull the dispenser
from the bottom up and pull out.
When pulling out the dispenser from the
door, lift slightly the bottom of dispenser
inside, then remove the "Bottom" jig.
※ Be careful injury on your hand.
LDF5545ST