Related Manuals for Alentec & Orion 24720
Summary of Contents for Alentec & Orion 24720
- Page 1 USER MANUAL / BRUKSANVISNING / MANUEL D’UTILISATION / BEDIENUNGSANLEITUNG / MANUAL DE INSTRUCCIONES IN LINE METER Part No. / Réf. / Art. Nr. / Cód.: 24720 Manual 24720_EN_2B 2014-05-20...
-
Page 2: Table Of Contents
Manual 24720_EN_2B INTRODUCTION MECHANICAL INSTALLATION BATTERIES HOW TO USE 4.1. HECK BEFORE USE 4.2. ISPENSE FLUID 4.3. “T ” COUNTER 4.3.1. Check the “Trip” counter ........................4 4.3.2. Reset the “Trip” counter ........................4 4.4. “T ” OTAL COUNTER 4.4.1. Check the “Total”... -
Page 3: Introduction
Manual 24720_EN_2B 1. Introduction The In line meter 24720 is used to measure the volume of fluid filled in an object. The meter is based on the “oval-gear” Principe. It uses permanent magnets and REED-switches as signal pickup. The integrated valve is pressure balanced to enable a smooth flow control almost independent of fluid pressure. -
Page 4: Trip" Counter
Manual 24720_EN_2B 4.3. “Trip” counter The meter is equipped with a “Tripp” counter that shows the accumulated volume of fluid dispensed since it was last “RESET”. The “Trip” counter can be zeroed, “re-set”. 4.3.1. Check the “Trip” counter When the meter is in normal dispense mot the TRIP-counter can be shown by pressing the <Select> button. Normal dispense mode. -
Page 5: Calibration
Manual 24720_EN_2B 5. Calibration Normally the meter does not need calibration if it is used for normal workshop oils but if fluids with high or low viscosities or high or low flows are used calibration may be needed. Also calibration may be needed after a long time of use especially if dirt is present in the fluid. To make a usable calibration some rules has to be followed. -
Page 6: Unit Used For Measuring
Manual 24720_EN_2B Then press <SELECT> and the display will move on to received volume input. The first figure will “blink” to ◄ ▬ ► show that it is changeable. Press <RESET> to change the value press <SELECT> to change to the next figure. In this example we received 1.6852 L so we move to second figure with <SELECT>... -
Page 7: Lcd Segment Test
Manual 24720_EN_2B 5.3. LCD segment test The LCD can be checked by putting the meter in normal dispense mode. Normal dispense mode. Press <RESET> and the meter will do a re-set and show all the segments of the LCD for a short while. 5.4. -
Page 8: Technical Specification
Manual 24720_EN_2B 6. Technical specification Type: Oval gears on steel shafts in a casted metal chamber with pressure drain grooves. Pickup system: 4 pieces of permanent magnets on one of the gears configured North-South-North-South to eliminate magnetic history. The rotation is detected through the measuring chamber lid by a REED-switch on the electronic printed circuit board eliminating the risk for shaft leakage.
Need help?
Do you have a question about the 24720 and is the answer not in the manual?
Questions and answers