Advertisement
Introduction
HELO Plus requires a network connection and is shipped from the factory
with DHCP enabled. If your network has a DHCP server, by simply connecting
HELO Plus to your network with an Ethernet cable, the DHCP server will assign
HELO Plus a compatible IP address. However, you will need to know that IP
address before you will be able to access HELO Plus's internal web server for initial
configuration. AJA 's eMini-Setup application was designed for that purpose.
For streaming or recording to a network drive, additional HELO Plus
configuration is required. A properly configured HELO Plus can stream and record
simultaneously or perform each task individually.
HELO Plus Initial Configuration
CAUTION: Please use caution and take security into account when configuring your
DHCP Configuration
1. Acquire eMini-Setup from the AJA website and install it onto your computer.
https://www.aja.com/family/software#eminisetup
2. Connect the HELO Plus's USB Config port to that computer's USB port.
3. Launch the eMini-Setup application on your computer. The eMini-Setup
Network tab will display the HELO Plus's current IP network settings.
4. If your HELO Plus is connected to a network using DHCP, the DHCP assigned
IP address is shown. Enter that IP address into a web browser on your
connected computer. The HELO Plus's internal web page will be displayed,
allowing complete control of the device.
Static IP Address Configuration Using eMini-Setup
IMPORTANT: Record your computer's existing TCP-IP settings before you change any of
1. Ensure the HELO Plus's USB Config port is connected to your computer, and
the HELO Plus's Ethernet port is also connected to your computer, either
directly or via a non-DHCP network.
2. Launch the eMini-Setup application and go to the eMini-Setup Network tab.
Published March 9, 2023
HELO Plus Quick Start Guide v1.0
HELO Plus
Quick Start Guide
HELO Plus unit on your network. It is recommended that you place your HELO Plus
behind a firewall so that it is not accessible on the open Internet by unauthorized
users. If you have questions or concerns about how to configure HELO Plus in a
way that is appropriate for your security needs, please consult with your IT staff or
a qualified network security consultant.
those network settings so that you can easily return your computer to normal
network operation.
1
www.aja.com
Advertisement
Table of Contents
Related Manuals for AJA HELO Plus
Summary of Contents for AJA HELO Plus
- Page 1 HELO Plus to your network with an Ethernet cable, the DHCP server will assign HELO Plus a compatible IP address. However, you will need to know that IP address before you will be able to access HELO Plus’s internal web server for initial configuration. AJA 's eMini-Setup application was designed for that purpose.
- Page 2 4. You now should now be able to make any necessary network configuration changes. A. You can use eMini-Setup to edit the HELO Plus's static IP address to be compatible with your computer's current network settings. B. Alternatively, you can change your computer's IP settings to be compatible with the HELO Plus's static IP address.
Need help?
Do you have a question about the HELO Plus and is the answer not in the manual?
Questions and answers