Positioning The Xm Passport System; Xm Radio Messages - Onkyo TX-8522 Instruction Manual

TX-8522_XMsection.book 7 ページ ２００６年５月２日 火曜日 午後１時４１分

Positioning the XM Passport System

You can check the signal strength of the XM radio signal
and adjust the position of the XM Passport System
accordingly.
1 Press the [SETUP] button on the
remote controller.
2
Use the Up and Down [
buttons to select "ANT Aiming,"
and then press [ENTER].
3 Adjust the position of the XM
Passport System so that the SAT
signal strength bar is as long as
possible.
If you can't receive a satellite signal,
press the Down [
the terrestrial (TER) signal strength
meter and adjust your XM Passport
System so that the bar is as long as
possible.
Terrestrial signals are only available in
certain areas.
So long as the signal strength is good,
you can enjoy XM Radio by using
either satellite or terrestrial reception.

XM Radio Messages

The following messages may appear while using XM
radio.
The XM Passport System is not connected properly.
Check the connection.
]/[ ]
The XM user encryption code is being updated. Please
wait.
The signal is too weak. Check the XM Passport System
connection and reposition it for the best reception.
] button to display
The receiver is tuning or decoding audio or text data.
Please wait.
The XM channel you selected is not currently
broadcasting. Select another channel.
SETUP
/
7