INSPECTION
All parts should be washed in a clean solvent before they are inspected and
•
reassembled.
USE CLEANING FLUIDS THAT ARE NONFLAMMABLE AND AVOID
BREATHING THE FLUID VAPORS.
Handle all parts carefully, hardened parts may chip if dropped on a hard surface.
•
BACKHEAD
Inspect the threads and pin hole for cracks and burrs.
•
Remove all burrs on the thread with a fine file or emery cloth.
•
Replace if necessary.
•
CHECK VALVE - ALUMINUM
The check valve should be smooth and free from abrasions.
•
Replace if necessary.
•
Replace the check valve spring if it is worn or broken.
•
FEED TUBE ASSEMBLY
Inspect the outside diameters for nicks, burrs and scoring.
•
Inspect all makeup surfaces for indentations or nicks caused by wear.
•
Remove all minor irregularities with emery cloth.
•
Replace if necessary.
•
PIN
Inspect pin for scoring or cracks.
•
Replace if necessary.
•
Page 8
WARNING
Patriot
125/125HD
02/09/23