Step 1
Remove the colored timbers from the package and lay them down to
form the desired shape. Remove the packages of stacking joints.
Step 2
Insert the gap fillers into
the ends of all joints as
shown in image 1.
Step 3
Snap the joints over the ends of
the timbers by lining up the hole
in the timber with the locking
point on the joints as shown in
images 2a and 2b. Gap fillers
should be at the top (rounded)
edge of the timbers and joints
should go in opposite directions
as shown in image 3. Repeat for
all 6 timbers.
Step 4
In the desired sandbox location, stand the
timbers up with the rounded edges at the
top. Join each timber by inserting a stake –
pointed side up – through the joints as shown
in image 4. Repeat for all timbers.
CRAYOLA® SANDBOX INSTRUCTIONS
Square Sandbox - each package should contain:
4 stakes, 4 joints, 4 joint caps, and 8 gap fillers.
Hexagon Sandbox - each package should contain:
6 stakes, 6 joints, 6 joint caps, and 12 gap fillers.
Image 1
Image 2a
Image 3 - joints should go in opposite directions.
Image 4
Image 2b
Need help?
Do you have a question about the Square Sandbox and is the answer not in the manual?
Questions and answers