Installation - AquaScape 75000 Instruction And Maintenance

Installation

STEP 1
UNPACK KIT COMPONENTS
• Carefully unpack the kit components.
STEP 2
SELECT LOCATION
• Select an indoor location
for the pond aerator pump
that is protected from the
weather. The location needs
to be dry and free from
airborne dust and debris.
If possible position or raise
the unit so it rests above
the pond water level to help
protect the air pump from water damage.
NOTE: DO NOT submerge the pond aerator pump in
water.
STEP 3
LAYOUT AERATION
TUBING
• Lay out the aeration tubing
with pre-installed check
valves.
STEP 4
ATTACH TUBING
• Attach the end of aeration tubing with the pre-installed
check valve to the front nozzle on the air pump.
NOTE: The check valve is designed to prevent water from
siphoning back through the tubing and entering into the
compressor. Failure to install the check valve may result in
the compressor being permanently damaged, voiding the
warranty.
☎
aquascapeinc.com | CAN (866) 766-3426 |
Check Valve
OR
☎
US (866) 877-6637
STEP 5
ATTACH AERATION DISCS
• Attach the aeration discs
to the opposite end of the
aeration tubing.
STEP 6
POSITION AERATION
DISCS IN POND
• Position the aeration discs
in the bottom of the pond.
We recommend separating
the aeration discs apart
from each other to maximize
the circulation throughout
the entire pond.
STEP 7
PLUG IN PUMP
• Plug the pump to a ground
fault circuit interrupter (GFCI)
rated receptacle and enjoy
the benefits.
TIP: Small rocks
or gravel can be
used to hide the
aeration tubing
and prevent it from floating, or
to secure the aeration disc in the proper position.
Suggested Pond Installation
5