Advertisement
Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
WARNING
- DO NOT overfill the pool and/or allow people to lay over or sit on the pool wall - DOING SO
CAN CAUSE PERMANENT INJURY! Drain the pool to the proper level after heavy rain.
TIP
: It will be much easier to install your pool if you unfold it and let it lay in direct sunlight for about 2 hours prior to
installation. This will help ensure a wrinkle-free fit because the pool material will be more pliable, allowing it to form
into shape during installation.
WARNING
- IMPORTANT! SITE MUST BE LEVEL, STABLE, COMPACTED SOIL.
•
The pool must be assembled on a smooth and level site of firm soil that is free of stones, gravel, sticks, blacktop,
or other oil-based compounds.
•
Before setting up your pool, it is recommended that you clear the area of hardy grasses. Certain types of vigorous
grasses such as St. Augustine and Bermuda can grow through the liner. A ground sheet or tarp may be helpful in
preventing this from occurring. Grass growing through the liner is not covered under warranty.
•
Do not install the pool on a wooden deck or any type of wooden surface. You cannot use sand and/or
uncompacted soil to provide a level surface for the pool; it will wash out.
•
FAILURE TO FOLLOW ALL OF THESE INSTRUCTIONS WILL CAUSE THE POOL TO COLLAPSE AND WILL
VOID THE WARRANTY!
Site Preparation
1.
Select a level area, and completely remove all debris, twigs, stones, etc. DO NOT select an area under overhead
electrical lines, trees, or within 4.57 m (15 ft) of a house, building, etc.
2.
The pool shall be located a minimum distance of 1.83 m (6 ft) from any electrical receptacle.
3.
Contact your local utilities, to check that no underground cables, telephone lines, gas lines, etc. run beneath the area
you have selected.
Follow the steps as illustrated in "Setup Diagrams No.1 to 11" to set up your pool.
Not following the steps will result in an uneven pool when it is filled with water, and may cause the pool to lean on one
side and collapse. Your pool should be straight and verticle to the ground. If you pool is leaning at all, the ground may not
be levelled and you will need to set up the pool again.
Failure to follow the instructions above will cause pool to collapse and will void the warranty!
Note
IMPORTANT:
Before adding water to your pool, you must first install the pool wall fittings or an entire filtration system.
If your pool includes openings or if you plan on purchasing a filter pump system, position the suction and return fitting
locations so they are 10 to 21 feet from the electrical outlet you plan to use for the pool filter pump.
If your pool came with fittings, install both the suction and return fittings to the pool wall before filling the pool with water.
Refer to the filter pump's instruction manual for the steps to set up the fittings.
The black rubber gasket (Fitting Gasket) should always be slid over the threated plastic suction or return fitting, and also
be on the inside of the pool before the fitting is placed through the pool wall to make a secure watertight connection.
Make sure both the water cap and the service plug is secure when you fill up your pool with water, or when you are ready
to add a filtration system.
8
SETUP INSTRUCTIONS
Hide quick links:
Advertisement
