Technical Specifications; Power Requirement; Audio Performance; Dimensions And Weight - MasterSounds Two Valve MK2 Manual

TECHNICAL SPECIFICATIONS

POWER REQUIREMENT

(Each mixer is supplied with a compact switch-mode power supply for anywhere
in the world and we supply the correct IEC lead for your country)
External Power Supply - Universal 90V – 265V AC 50/60Hz 18v 30W Max
DC Internal Power Rails - +/- 18V DC

AUDIO PERFORMANCE

THD+N OdBu Line In to Mix Out: 0.05%
+10dBu Line in to Mix Out: 0.1% Frequency Response 20Hz to 120kHz: +1/-2dB
Noise unity Line In to Mix Out: -88dBu unweighted.
Residual Mix Noise: -110dBu unweighted.
High-Pass Filter frequency range: 18Hz – 1.8kHz
Dynamic Range - >116dB
Maximum Signal Level - ±27dBu
Headphone Output Power - 800mW RMS into 32 Ohms
EQ/FILTERS
Channel EQ - 3 Band -20/+6dB
Channel EQ Frequency - 150Hz, 1kHz, 2kHz
Master EQ/Isolator Cut/Boost - OFF to +12dB
Master EQ/Isolator Crossover Fc - 350Hz and 3.5kHz
RIAA Accuracy - Within 0.25dB 40Hz – 20kHz
DIMENSIONS & WEIGHT
W = 230 L = 283 H = 84 (mm)
**PLEASE NOTE** This is the Faceplate size. Not including knobs, Sockets,
Headphone Jack, Cabling ETC.
Weight = 3.3KG
Packed Dimensions
W = 351 L = 351 H = 180 (mm)
Packed weight = 5.5KG
WARRANTY
MasterSounds warrants that the Mixer shall be free of defects in workmanship
and materials for a period of twenty-four months from the date of purchase. In
the event that the product fails to operate as intended, MasterSounds will
repair or replace the product subject to the following conditions.
• That the failure was not due to improper installation, operation, cleaning
or maintenance, accident, damage, misuse, abuse, or non-approved
modifications to the Mixer.
• The warranty does not cover normal wear and tear or any other event, act,
default or omission outside MasterSounds control.
• Faulty products must be returned to MasterSounds or an authorised service
agent along with the original invoice or proof of purchase, and the mixer
must be returned packed in the original shipping box. Please contact
MasterSounds before shipping a faulty unit.
• The warranty applies only to the original purchaser and is not
transferrable.
• At their sole discretion, MasterSounds may either repair the defective
product or replace with an equivalent service exchange item.
• This warranty constitutes the purchaser's sole remedy. MasterSounds shall
not be liable for any other repair or replacement cost or any damage or loss
directly or indirectly related to the malfunction of this mixer.
Pots & switches & crossfaders are warranted for 3 months from the date of
purchase.
MasterSounds VALVE Series complies with the European Electromagnetic
Compatibility directives 2014/30/EU and the European Low Voltage directives
2014/35/EU.
VALVE Operation Manual
Copyright © 2023 MasterSounds Audio. All rights reserved
www.mastersounds.co.uk