Advertisement
6. HOW TO DISASSEMBLE
6-1 REPLACEMENT OF MAIN PCB-ASS'Y
1) Remove the two cover-screw and then a screw 2EA as
shown in the figure
2) Lift up the CONTROL-PANEL by pushing it slightly
from right to left as shown in the figure here.
3) Turn the CONTROL-PANEL ASS'Y and remove 4EA
screws securing PCB ASS'Y.
4) Raise the ass'y gently to the direction to which the
screw are removed in order to separate the ass'y.
5) Disconnect the Wire Harness from ASS'Y PCB.
- Do not allow wire to get too much tension when
replacing control-panel.
- When assembling PCB, check if CONTROL-PANEL
fixing HOOK is properly positioned and tighten with
screws. (If not tightened exactly, Select S/W does
not operate.)
- Check the working condition of each parts (use test
mode)
26
Advertisement
