Sensor Unit Measurements; Attaching The Sensor Unit Cover - Casio CMT-S20R-AS User Manual

Sensor Unit Measurements

✹
IMPORTANT!
• If you do not start measurement within about 60 minutes after turning on the
sensor unit, it will turn off automatically. The "Automatically turn off (auto power
off)" setting can be changed with the Runmetrix app.
• You can use the Runmetrix app to check the remaining battery charge and the
remaining recording capacity.
• Remove the instructional sticker from the sensor unit before using it.
• Leaving the sensor unit on a hot surface or leaving it exposed to direct sunlight
for long periods can cause the sensor unit to turn off automatically.
• Do not use the sensor unit while it is being charged using a mobile battery.
Doing so can cause incorrect measurement results.

Attaching the Sensor Unit Cover

1.
Attach the sensor unit cover.
Unlock the slide lock of the sensor unit by sliding it upwards.
With the clip open, insert the sensor unit into the sensor unit cover, [USB]
cover end first.
[USB] cover
Insert the button side of the sensor unit into the sensor unit cover.
• Wrap the sensor unit cover over one corner of the sensor unit and then
over the other corner.
Make sure that the [USB] cover, [
unit are not covered.
✹
IMPORTANT!
• Attaching the sensor unit without the sensor unit cover can result in skin
irritation due to friction. Attach the sensor unit cover before use.
Slide lock
Sensor unit
cover
] lamp, button, and LED of the sensor
6