Advertisement
2.
Preparations for IP Camera Setup
This chapter provides information about system requirements for IP Camera
operation, power connection, Ethernet connection and ways to access to the
camera.
2.1
System Requirements
To perform the IP Camera via web browser, please ensure your PC is in good
network connection, and meet system requirements as described below.
Items
Personal Computer
Operating System
Web Browser
Network Card
Viewer
2.2
Installation
Please read the instructions provided in this chapter thoroughly before installing
the Full HD Multi-Res Vandal Proof IP Dome Camera.
2.3
Power and Ethernet Cable Connection
Power Connection
Make sure the camera's power cable is correctly and firmly connected; refer to
the pin definition table in section
Ethernet (PoE), make sure Power Sourcing Equipment (PSE) is in use in the
network.
Ethernet Cable Connection
Use of Category 5 Ethernet cable is recommended for network connection; to
have best transmission quality, cable length shall not exceed 100 meters.
Connect one end of the Ethernet cable to the RJ-45 connector of the IP Dome
Camera, and the other end of the cable to the network switch or PC.
System Requirement
○
○
1. Intel
Pentium
R
R
2.0 GHz
2. 2 GB RAM or more
Windows VISTA or Windows XP
Microsoft Internet Explorer 6.0 or later
10Base-T (10 Mbps) or 100Base-TX (100 Mbps) operation
ActiveX control plug-in for Microsoft IE
1.4 Camera's
M, 2.16 GHz or Intel
Connectors. If using Power over
○
TM
Core
2 Duo,
R
7
Advertisement
