Advertisement
8. Insert the Handle (B) end with hole into the Steering
Assembly (J). Insert the 2-5/8" Bolt (K) through the
Steering Assembly, Handle, and back through the
other side of the Steering Assembly, and secure
in place with a Small Washer and Nut Cap.
9. Turn the Wagon over so the Tray (A) faces
up. Assemble one (1) of the Long Side Panels
(E) to the wagon with the three 1-3/4" Bolts
(K) going through the Tray from the inside
first and then each vertical slat. Secure them
in place with Washers and Nut Caps.
Parts List and Diagram
Part
Description
A
Tray
B
Handle
C
Wheel
D
Turntable
E
Long Side Panel
F
Short Rear Panel
G
Short Front Panel
H
Rear Axle Assembly
I
Rear Axle Brace
J
Steering Assembly
E
G
M
M
Item 60570
F
For technical questions, please call 1-888-866-5797.
Note: The Short Front Panel (G) is the one
with a downward curved front slat.
10. Assemble the Short Rear Panel (F) to the Tray (A)
with two 1-3/4" Bolts (K) going through the Tray
from the inside first and then each vertical slat.
Secure them in place with Washers and Nut Caps.
11. Assemble the second Long Side
Panel (E) as in step 9.
12. Assemble the Short Front Panel (G) with two
1-3/4" Bolts (K) going through the Tray from the
inside first and then each vertical slat. Secure
them in place with Washers and Nut Caps.
Part
Qty
K
Assembly Hardware set contains:
1
1-3/4" M6 Round Head Bolt Set*
1
2-5/8" M6 Round Head Bolt Set* (handle)
4
1/2" M6 Bolt Set* (axle, steering yoke)
1
1-1/4" Axle Washer
2
Axle Cap
1
1-1/8" Bolt with hole
1
Bolt Cotter Pin
1
7/8" Turntable Washer
2
Turntable Lock Washer
1
Turntable Nut
M
Steering Washer
*Bolts include flat / l ock washers and nuts / c aps.
C
H
I
Description
J
D
A
Qty
-
10
1
8
4
4
1
1
1
1
1
2
B
Page 3
Advertisement
