Advertisement
Specifications
IMPORTANT SAFETY INFORMATION
Read all safety warnings and instructions.
Failure to follow the warnings and instructions may result in serious injury.
Save all warnings and instructions for future reference.
1. AGES 5 AND UP ONLY.
Do not allow younger children to use.
2. WEAR PROPER SAFETY HELMET AND
COMPLETE SAFETY GEAR WHEN RIDING.
Responsible adult must supervise during use.
Use as intended only.
Rider must stay seated at all times during use.
Do not allow more than one child
to play with tricycle at once.
3. Do not use in unstable or dangerous area.
Tipping over can cause injury.
Do not use in areas where vehicles may be present,
such as parking areas, driveways, or roads.
Assembly
Note: For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram on facing page.
Note: Bolts include flat / l ock washers and nuts / c aps. Do not overtighten hardware.
1. Place the Tray (A) upside down on saw horses or
other sturdy supports with the bottom facing upwards.
2. Use two 1/2" Bolts (K) to secure the Rear Axle
Assembly (H) to the holes located on the rear of the
Tray (A). Insert the Bolts through the Tray and then
the Rear Axle Assembly. Secure it in place with the
Washers and Cap Nuts (K) on the Tray's underside.
3. Slide each Rear Axle Brace (I) over each end
of the Rear Axle until they sit firmly next to the
bracket of the Rear Axle Assembly (H). Align the
end of the Braces with the holes in the Tray (A).
Insert two 1/2" Bolts (K) through the Tray and
then the Braces. Secure them in place with the
Washers and Nuts on the Tray's underside.
Page 2
Tires
Age Range
Weight Capacity
Deck Size
Inside Dimensions
Replacement Wheels
For technical questions, please call 1-888-866-5797.
10" Pneumatic
5 and up
330 lb.
33-5/8" x 15-3/4" x 5-1/2"
31-7/8" x 13-3/4" x 4"
Harbor Freight Item 30900
4. Wear ANSI-approved safety goggles
and work gloves during assembly.
5. Read manual before assembly and/or use.
6. Do not exceed 330 lb. capacity.
7. Inspect before every use;
do not use if parts loose or damaged.
Check and tighten hardware periodically.
8. Assemble completely according to instructions
before allowing a child to play with this product.
4. Place a Steering Washer (M) into the Turntable
(D), and into the Steering Assembly (J). Attach the
Turntable (D) to Steering Assembly (J) using 1-1/8"
Bolt with a Hole (K). Slide Bolt through underside of
the Steering Assembly and into the Turntable. Secure
it with the 7/8" Washer, Large Lock Washer, and nut
(K). Leave the nut loose on the Bolt. Insert the Cotter
Pin (K) through the Bolt hole and spread it open.
5. Attach the Steering Assembly (J) / T urntable (D)
assembly to the Tray (A) with the four 1/2" Bolts (K)
inserted through the Tray and then the Turntable.
6. Slide a Wheel (C) onto each axle end with the Air
Valve facing out. Slide one 1-1/4" Axle Washer
(K) onto each axle next to each Wheel.
7. Place an Axle Cap (K) on each Axle end.
Item 60570
Advertisement
