Garmin StreetPilot c320 Setup Manual page 2

WARNING: See the product information sheet in the product box for product warnings
and other important information.
Step 1: Configure Your c320
Press and hold the
instructions to set up your c320; you only have to do this once.
Step 2: Install Software and Load Maps
Before using your c320, install software on your computer using the DVD-ROM, and then
load maps on your c320. Refer to the setup guide for complete instructions.
Step 3: Mount Your c320
To ensure a tight grip, clean and dry the windshield before mounting the suction cup.
1
1. Plug the small end of the cable into the
mount and the other end in a 12-Volt
receptacle in your vehicle.
2. Place the suction cup on the windshield.
3. Flip the lever back, toward the windshield.
If necessary, use the tension knob to improve your viewing angle.
Power button on the side of the unit to turn it on. Follow the on-screen
3
2
4
4. Fit the bottom of your c320 into the
cradle of the suction cup mount.
5. Tilt your c320 back until it snaps in
place.
5
Tension knob