Installation For Ce Compliance - Arcom PCO24 Technical Manual

J224 PCO24 2192-10479-000-000

Installation for CE Compliance

To maintain compliance with requirements of the EMC Directive (89/336/EEC) this product
must be correctly installed. The PC in which the board is housed must be CE compliant as
declared by the PC Manufacturer. The external I/O cable should be Arcom CAB50CE or a fully
screened cable to the same pattern.
1. Remove the cover of the PC observing any additional instructions of the PC manufacturer.
2. Locate the board in a spare ISA slot and press gently but firmly into place.
3. Ensure that the metal bracket attached to the board is fully seated.
4. Fit in the bracket clamping screw and firmly tighten this on the bracket.
5. Fit the screened I/O cable to the 50-way board connector.
6. Ensure that the jack screws for the cable connector are tightened (use a screw driver).
7. Replace the cover of the PC observing any additional instructions on the PC manufacturer.
The following standards have been applied to this product:
BS EN50081-1: 1992 Generic emissions standard, Domestic, commercial, light industry
BS EN50082-1: 1992 Generic immunity standard, Domestic, commercial, light industry
BS EN55022 : ITE Emissions, Class B, Limits and methods.