SETTING THE TIME When the time interface is displayed • onscreen press and hold the button to enter time setting mode. Tap the button to switch • between the following settings (in sequence): 12/24-Hour time > Hours > Minutes > Exit time setting mode.
Page 6
When the time interface is displayed • onscreen tap the button to enter alarm setting mode. turn alarm on/off. • Tap the button to switch • between AL1, AL2, AL3. Press and hold the button to • enter the time setting mode for the chosen alarm.
DISPLAY BRIGHTNESS When the time interface is displayed • onscreen tap the button to enter the display brightness mode. to change between 5 display • brightness modes. to exit the display • brightness mode. BRIGHTNESS SETTING Display brightness according to time 1 –...
Page 8
PHONE & EARBUD CHARGING Place a QI compatible phone or • earbuds case on the centre of the phone charging surface or earbud charging surface. Fast charging up to 15W is • supported when charging a phone (not earbuds), provided you are using the supplied cable and a fast-charging compatible adapter.
Page 9
WATCH CHARGING Place your watch on the watch • stand. Connect the charging cable that • was originally supplied with your watch to the watch charging output on the back of the charger, then to your watch.
Page 10
TIPS FOR SAFE CHARGING AVOID OVERCHARGING. Disconnect chargers and devices after the battery reaches a full charge. Leaving devices on a charger too long can cause them to overheat and can reduce battery life. PICK THE RIGHT CHARGER. Only use the charger and cable that came with your device.
Page 11
TIPS FOR SAFE CHARGING continued... CHARGE ONLY ON NON-FLAMMABLE SURFACES. Devices and chargers can get warm or sometimes even hot during charging. Make sure to always place the device and charger on a non-flammable surface when charging. Do not place on beds, pillows, paper, or near any fabric such as curtains or clothing under any circumstances.
Page 12
TIPS FOR SAFE CHARGING continued... MONITOR CHARGING. Recharge your devices while you are nearby, preferably in the same room or another room close by. This way when there is a defective battery or charger, you can take it off the power supply immediately.
TROUBLESHOOTING SLOW CHARGING: Check there are no obstructions on the • back of your device such as credit cards or metal objects. Put the device on the centre of the • charging surface. Phone cases cannot be thicker than • 5mm.
Page 14
TROUBLESHOOTING continued... Check if your phone supports Qi • Wireless Charging. Only iPhone models 8 and up support Qi Wireless Charging. Check you are using an adapter that • does not exceed the input and output ratings as shown in the specifications. DEVICE OR CHARGER GETS VERY HOT DURING CHARGING: It is normal for the charging coil to...
Page 15
Thank you for your purchase! Laser Corporation is 100% Australian owned & operated. To get the most out of your product please read the user manual carefully and keep for future use. For specific information relating to your product such as Spare Parts, FAQs, Warranty claims, and...
Page 16
Visit our website www.laserco.com.au Check us out at www.youtube.com/lasercoau...
Need help?
Do you have a question about the WLC-3IN1A-098 and is the answer not in the manual?
Questions and answers