Copying On Dual Drive Systems - TRIGEM CW3S20C Operation Manual

Copying on Dual Drive Systems

To make backup copies of your MS-DOS diskettes on a dualdrive
system, follow the instructions below:
First, turn your computer on and boot up MS-DOS. Choose
the Command Prompt option from the DOS shell menu.
The system prompt will appear. Enter the following command:
This command indicates to MS-DOS that you want to copy
the contents of a diskette in the A drive to a new diskette
located in the B drive.
The following message will be displayed:
The "SOURCE" diskette is the disk that you will be copying
from. The "TARGET" diskette is the one you will be copying to.
Put your master MS-DOS diskette in the A drive, and a new,
blank diskette in the B drive.
Warning!
If you have any doubts about which diskette goes in which
drive, check them carefully. Make sure that the write
protect notch on the master MS-DOS diskette is covered
with a
Using
4-16
tab.
write protect
MS-DOS With Your Computer