Internal Hard Disk Drive - TRIGEM CW3S20C Operation Manual

Internal Hard Disk Drive

If you are to mount the internal hard disk drive inside the main
system unit case, follow the steps below:
Remove the cover from the main system unit, as described
above.
Remove mounting plate by unscrewing the hold down
screws.
Attach the hard disk drive to the mounting plate by
installing the four mounting screws through the bottom of
the plate into the bottom of the drive frame.
Replace the mounting plate onto the mounting frame by
sliding the plate into the two openings provided in the
mounting frame.
Replace the hold down screws.
Connect the hard disk drive controller cables to the drive.
Replace the main system unit cover.
Your
Expanding
System 7- 15